Rheem GTC Series Guía para resolver problemas descargar pdf (Pagina 18)

INTELLI-VENT TROUBLESHOOTING GUIDE

15 of 24

ERROR CODE 14 - RESISTOR WIRE OPEN OR SHORTED

The self-diagnostic test found a problem with the black resistor wire on the ignitor

assembly plug; the resistor wire is open or shorted. (see 6)

Check / Repair:

• Insure the black resistor wire is not cut, missing, and is installed between pins 3 &

4 of the ignitor assembly plug. Replace ignitor assembly if damaged or defective.

• Unplug the ignitor assembly plug from the control. Check the resistance of the

black resistor wire between pins 3 & 4 with an ohm meter.

A If the reading taken is less than 2000 or more than 1.7 million ohms, replace

the ignitor assembly.

B If the reading taken is between 2000 and 1.7 million ohms, replace the Intelli-

Vent™ control.

ERROR CODE 15 - RESISTOR WIRE RESISTANCE OUT OF TOLERANCE

The self-diagnostic test determined the resistance of the black resistor wire on the ignitor

assembly plug is not within tolerance. (see 6)

Check / Repair:

• Unplug the ignitor assembly plug from the control. Check the resistance of the

black resistor wire between pins 3 & 4 with an ohm meter.

A If the reading taken is more than 50,000 ohms replace the ignitor assembly.

B If the reading taken is less than 50,000 ohms replace the Intelli-Vent™ control.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Sin comentarios

Rheem GTC Series Guía para resolver problemas Pagina 18