Rheem GTC Series Guía para resolver problemas descargar pdf (Pagina 6)

INTELLI-VENT TROUBLESHOOTING GUIDE

3 of 24

INTELLI-VENT™ OPERATION

PRE START UP CHECK LIST

• Correct polarity on electrical supply

• Water heater is properly grounded

• Owner’s manual safety statements have been reviewed

START UP PROCEDURE

1 Plug in water heater and turn on power. All lights on the control will come on for

about 1 - 5 seconds. All lights will then turn off. If the stored water is above 70°F

(residential) and the control setting has not been increased from it’s factory setting,

nothing more will happen. (Residential controls are factory set at 70°F, the “vacation”

setting per ANSI requirements; Commercial controls are factory set at 120°F)

2 Wake Up the control by holding down both of the temperature adjust buttons at the

same time for about one second; then release the buttons and the LED lights will

indicate the current temperature setting.

3 Push then release the “hotter” temperature adjust button repeatedly to increase the

water temperature setting and the “colder” temperature adjust button to decrease the

setting.

THE RECOMMENDED STARTING TEMPERATURE IS 120°F

See the illustration on the following page indicating which temperature setting

corresponds to the various combinations of LED lights.

SLEEP MODE - NORMAL OPERATION

Without any further user input the control will go back into the “sleep mode” in 30

seconds. All LED indicator lights will turn off. This is the normal operating mode.

6 LED indicator lights

• Temperature Settings

• Error Codes / Diagnostics

Temperature adjust buttons

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

Sin comentarios

Rheem GTC Series Guía para resolver problemas Pagina 6