Rheem R-410A Manual de usuario descargar pdf (Pagina 6)

CUSTOMER SATISFACTION ISSUES

• The condenser should be located away from the living, sleeping and recreation-

al spaces of the owner and those spaces of adjoining property.

• To prevent noise transmission, the mounting pad for the outdoor unit should

not be connected to the structure, and should be located sufficient distance

above grade to prevent ground water from entering the unit.

NOTE: Tubing installed in walls may cause noise issues.

UNIT MOUNTING

If elevating the condensing unit, either on a flat roof or on a slab, observe the

following guidelines.

• The base pan provided elevates the condenser coil 3/4” above the base pad.

• If elevating a unit on a flat roof, use 4” x 4” (or equivalent) stringers positioned

to distribute unit weight evenly and prevent noise and vibration.

NOTE: Do not block drain openings shown in Figure 1.

FACTORY-PREFERRED TIE-DOWN METHOD

FOR OUTDOOR UNITS

IMPORTANT: The Manufacturer approved/recommended method is a guide to

securing equipment for wind and seismic loads. Other methods might provide the

same result, but the Manufacturer method is the only one endorsed by Manufacturer

for securing equipment where wind or earthquake damage can occur. Additional

information is available in the PTS (Product Technical Support) section of the

Manufacturer website Rheemote.net and can be found as a listing under each out-

door model. If you do not have access to this site, your Distributor can offer assis-

tance.

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Sin comentarios

Rheem R-410A Manual de usuario Pagina 6